# -*- coding: utf-8 -*-
# -----------------------------------------------------------------------------
#
#  FreeType high-level python API - Copyright 2011-2015 Nicolas P. Rougier
#  Distributed under the terms of the new BSD license.
#
# -----------------------------------------------------------------------------
"""
An enumeration type that lists the render modes supported by FreeType 2. Each
mode corresponds to a specific type of scanline conversion performed on the
outline.

For bitmap fonts and embedded bitmaps the 'bitmap->pixel_mode' field in the
FT_GlyphSlotRec structure gives the format of the returned bitmap.

All modes except FT_RENDER_MODE_MONO use 256 levels of opacity.


FT_RENDER_MODE_NORMAL

  This is the default render mode; it corresponds to 8-bit anti-aliased
  bitmaps.


FT_RENDER_MODE_LIGHT

  This is equivalent to FT_RENDER_MODE_NORMAL. It is only defined as a separate
  value because render modes are also used indirectly to define hinting
  algorithm selectors. See FT_LOAD_TARGET_XXX for details.


FT_RENDER_MODE_MONO

  This mode corresponds to 1-bit bitmaps (with 2 levels of opacity).


FT_RENDER_MODE_LCD

  This mode corresponds to horizontal RGB and BGR sub-pixel displays like LCD
  screens. It produces 8-bit bitmaps that are 3 times the width of the original
  glyph outline in pixels, and which use the FT_PIXEL_MODE_LCD mode.


FT_RENDER_MODE_LCD_V

  This mode corresponds to vertical RGB and BGR sub-pixel displays (like PDA
  screens, rotated LCD displays, etc.). It produces 8-bit bitmaps that are 3
  times the height of the original glyph outline in pixels and use the
  FT_PIXEL_MODE_LCD_V mode.
  
FT_RENDER_MODE_SDF

  This mode corresponds to 8-bit, single-channel signed distance field (SDF)
  bitmaps. Each pixel in the SDF grid is the value from the pixel's position to
  the nearest glyph's outline. The distances are calculated from the center of
  the pixel and are positive if they are filled by the outline (i.e., inside
  the outline) and negative otherwise. Check the note below on how to convert
  the output values to usable data.
"""
FT_RENDER_MODES = { 'FT_RENDER_MODE_NORMAL' : 0,
                    'FT_RENDER_MODE_LIGHT'  : 1,
                    'FT_RENDER_MODE_MONO'   : 2,
                    'FT_RENDER_MODE_LCD'    : 3,
                    'FT_RENDER_MODE_LCD_V'  : 4,
                    'FT_RENDER_MODE_SDF'    : 5 }
globals().update(FT_RENDER_MODES)